Drag chain cables are widely used in recent years. They are special cables with relatively high process requirements and good performance in all aspects. Using environmental protection materials, ordinary wires and cables do not have this special performance.
Therefore, the drag chain cable is different from the general fixed installation cable, so it is necessary to avoid some "lightning points" during installation and use:
① Pay attention to the small bending radius of the drag chain cable.
② Cables shall be loosely filtered side by side, separated and arranged as far as possible. The spacing between the cables in the filter chain shall be at least 10% of the cable diameter. The cables of the traction chain shall not touch each other or be trapped together.
③ The point of the drag chain cable must be fixed, or at least at the moving end of the drag chain. Generally, the moving point of the cable must be 20-30 times the diameter of the cable at the end of the traction chain.
④ Ensure that the drag chain cable moves back and forth or vertically within the bending radius. This allows the cables to move relative to each other or relative to the guide device. After working for a period of time, confirm the position of the drag chain cable. Various inspections must be carried out after the push-pull movement.
⑤ If the running drag chain breaks, indirect cable damage caused by excessive tension is inevitable, so the drag chain cable needs to be replaced.
The drag chain cable has certain special properties such as flexibility, folding resistance, oil resistance, abrasion resistance and corrosion resistance. It is mainly used in special environments such as robot manipulator, servo system installation and traction system, with long service life. General cables can only be used for household appliances, power tools and power wiring, while this special cable needs to be used on the equipment to work with the equipment.





